M3 Mobile options
Glink sets Output Mode
When the Glink sets Output Mode option is enabled, Glink will set ScanEmul Output Mode to None while in the main emulator screen and set it to Copy and Paste when this screen is exited. When this option is disabled, Glink will not make any changes to the ScanEmul Output Mode. Disable this option when you do not want Glink to set the Default option to Copy and Paste when Glink exit, for example because other applications using the Default profile depend on a different setting.
When using an associated profile with Glink you should also disable the Glink sets Output Mode option in Glink, and set ScanEmul Output Mode to None (Copy to clipboard).
M3 ScanEmul app
The M3 ScanEmul app is used for the configuration of the scanner. A Default profile is defined, and this profile is set up to deliver scanned data with Intent Actions which is the preferred method to deliver scanned data to Glink. In Glink, the scanned data should be displayed both in the current input field and on the status line of Glink.
If scanned data is not displayed on the status line at the bottom of the Glink screen, check in the Barcode reader setup in Glink that M3 Mobile is selected as the device type. In the ScanEmul app check that Intent Output is enabled for the Default profile.
Prefix and suffix settings
When the scanner is set up to use Intent Action, Prefix, Suffix and Action after scan can be configured both in the ScanEmul app and in Glink.
Make sure to set these parameters in one place only.
Specific profile for Glink
In the ScanEmul app a new profile can be defined and associated with a given app, for example Glink.
In the main screen for the ScanEmul app select the Drop-down menu->Add Profile. Enter a name. Then select Associated Apps->Glink(VT/5250).
Please note that an app can only be associated with one profile at a time.