When Debug mode is enabled all data sent to and from the host is written to this Debug screen, and you will see a Debug icon at the top right of the screen, next to the Enter button. Tap the Debug icon to go to the Debug screen. The content of the debug screen can be printed or sent as an e-mail attachment and you can mark and copy selected text. If text is marked when you tap the Mail or Print button, only the marked text will be sent/printed.
You enable the text-marking feature by holding a finger on the screen until the magnifier appears. When you release the finger, you will have a start- and end-marker that you can move to the desired positions.
Tap Clear to clear the debug screen.
Tap Print to Print the debug screen. If text is marked when you tap the Print button, only the marked text will be printed. If no text is marked, you are allowed to select a Page Range before you print. You must select a printer and how many copies to print before tapping the Print button.
Tap Options to set Print options, like Font size and Page orientation.
Tap Mail to Mail the debug screen. If text is marked when you tap the Mail button, only the marked text will be sent. The debug text is sent as a file-attachment named debug.txt.
Tap Mail config to Mail your set of configurations to yourself for back-up purposes or to someone else for sharing. The configurations are sent as a file-attachment named config.xxx, where xxx is either glinki, glink5250, glink3270 or glinkvt; depending on the App you are using. When you tap Mail config, you will be asked if you want to include Connect macros (if you have any) before you are taken to the Send Mail function with your configurations attached to the message.
Tap Arrow-up icon to position at the start of the Debug buffer.
Tap Arrow-down icon to position at the end of the Debug buffer.
Tap the Glink button to return to the main screen.